Re: Crisis Recovery Jumper Z620 Z420 Z820 Revealed
Thank you both for the suggestions... I did get it to flash red and beep, but probably not the way it's meant to in this procedure... At first I tried with the PS/2 keyboard... No change; still the...
View ArticleRe: Crisis Recovery Jumper Z620 Z420 Z820 Revealed
swap cpu 0 with cpu 2 (again only run 1 cpu)
View ArticleRe: Crisis Recovery Jumper Z620 Z420 Z820 Revealed
Do you mean swap the CPU in socket 0 with the one from socket 1? (So still running a single CPU in socket 0)Or do you mean run with only a single CPU but in socket 1 instead of 0?(Just to clarify :))
View ArticleRe: Shrink C drive and create a swap partition
Hi wawood, Thnaks for the information, by the way i already did the same thing what did you mentioned! Now i am able to create one more drive whcih is called D in thin-client, actually i have created...
View ArticleRe: Crisis Recovery Jumper Z620 Z420 Z820 Revealed
take the cpu from socket 2 place in socket 1 (primary socket) leave socket 2 empty
View ArticleRe: HP z600 Processor Upgrade
I believe I have a version 1 board, boot block dat 1-30-09... Video card = AMD Radion R5 200. Also have a usb wifi dongle installed...
View ArticleRe: Crisis Recovery Jumper Z620 Z420 Z820 Revealed
IT'S ALIVE! :-))) After swapping the CPU, I got 8 beeps/flashes, and it fully reset. (Switched off and back on after a couple of seconds)Came back with a lot less fan speed.At first nothing more...
View ArticleClik here to view.
z620 cabling
I'm new to a z620 and I was trying to understand the cabling. The only one I'm sure about is #30 going to the DVDR/W. Where do the Sata3 #31 0 and 1 go? I gathered from top down 3.5 HDD are 0,1,2 but...
View ArticleRe: z620 cabling
the z620 sata ports do not really care what order a device is attached. the primary boot device can be on any port and work reguardless where the drive is located. you only need the pwr/data cables to...
View ArticleClik here to view.
Re: z620 cabling
I had read the maintenance c_04205252.pdf, but that made me want to make sure I would be getting the 6Mbit sata on the drives I wanted to be as fast as possible, but I could not be sure where those...
View ArticleCan I use a GTX Titan Z GFX Card ina HP Z600 Dual Xeon Workstation, and if...
Hello, I am trying to use a NVidia Geforce GTX Titan Z with a HP Z600 Workstation (Dual Xeon X5670, 32GB Ram, 1 SSD, 1 HD). In case you don't know this graphics card, this is a triple-slot monster with...
View ArticleRe: z620 cabling
all sata ports on the motherboard are 6gbps, so anything attached to the motherboard sata will by default be capable of 6gbps speeds,... assuming your storage device is also 6gbps capable pci-e slots...
View ArticleRe: Can I use a GTX Titan Z GFX Card ina HP Z600 Dual Xeon Workstation, and...
you people really need to stop trying to cram a v8 engine into a 69 beetle. you can not use a NVidia Geforce GTX Titan Z with a HP Z600 Workstation (Dual Xeon X5670, 32GB Ram, 1 SSD, 1 HD) replace the...
View ArticleRe: z620 cabling
According to the first jpg from that manual which is kind of hard to see unless enlarged, the first four SATA ports on the left are 3Mbits, the two on the right are 6Mbits and AHCI.
View ArticleRe: z620 cabling
Embossed in the silver metal edge of the drive drawers is, vertically oriented, 0,1,2. I use a fine tip Sharpie marker to fill those in so they are easy to see forever. Bottom drawer bay is 0 if I...
View ArticleRe: Shrink C drive and create a swap partition
Have you ever tried to shrink C and create a swap partition with CMD?
View ArticleRe: Can I use a GTX Titan Z GFX Card ina HP Z600 Dual Xeon Workstation, and...
DGroves: So, why, do you think, can I not insert another power supply with, say, 850 Watts in the HP Z600? Isn't there an adapter cable to do just that? How's about using a seperate power supply for...
View ArticleRe: Can I use a GTX Titan Z GFX Card ina HP Z600 Dual Xeon Workstation, and...
there are quite a few reasions, ranging from the z600 was not designed to have a 350 watt thermal load from the video card (plus your other items cpu, ram, drives) while there may be pwr supply...
View ArticleRe: Shrink C drive and create a swap partition
In our case there is only drive C when system is running os is using, so we can't schrink grpahically or cmd. we did by partioning tool while clienet booting.
View ArticleCan not update bios on Workstation HP Z820
Every time I try to update y bios (needed to install Thunbolt card) I have a error. I try it by update via Windows, via dos and a USB stick, via the setup (F10) . Version today: J63 V01.02.Error...
View Article