etem1976 wrote:Hi,
and good morning.
You right. I have get it the Message that Bios correctly updatet. OK then is that right.
But I can't see after Install Windows 10 x64 over USB ..x64.efi "Windows Boot Manager" . :-(
And when I have in Bios some Commands to EFI then I have Black Screen:
So I have programmied my Bios:
And installed the PCIe Controller Wings in Slot Number 22. In Slot 22 is Quadro K2000. And I have outside (at the Moment not installed) PCIe USB 3.0 Controller.
And when I start again from my Windows USB Stick to Install then I see Toshiba/OCZ have 4 Partitions: Recovery (450MB), System (100MB), MSR (16MB) and Primary (rest)
So I mean it is correctly installed in Toshiba drive in UEFI.
But the entry "Windows Boot Manager" is no in Bios. Thats my Problem :-(
When I than start it again without USB then I become Eror Non Disk....etc.
Thank You very much for your Help
The PCIe adapter card should be in slot 22 or 23 going by the HP diagram.
From what you write it seems that Windows 10 installed fine to the SSD NVMe drive.
Your bios settings also look fine so I am running out of ideas.
I would also try to disable Legacy Support, then going to the Device Options menu and ensuring everything is set to EFI, since from what I recall toggling this option changes those settings back to legacy.
Also, what happens if you set all the option roms (PXE, mass storage, video) to Legacy? Does this change boot behaviour?
