I just swapped a systemboard in an 800 G2. Finished installing it and went into the bios to set the system ID's.
I set them all and the computer yelled at me a few times for typo'ing the FeatureByte, then it took it. I rebooted and it popped me back into the bios asking if I wanted to commit the settings. Everything appears correct so I say yes.
It reboots again and now I am still seeing the "System is not fully configured" message on startup.
It gives me no indication what the problem is.
The System ID setup menu is gone now.
I tried booting into the bios and hitting ctrl-a to see if that would work, but I see nothing about system ID's in the security menu.
Any other suggestions to figure out what is causing this?