So I was upgrading my system with an PCIE to M2 card and decided to place it in slot 1 x8 (4). Card ran fine and fans ran as normal. Wanted to see if it would work fine in slot 4 x16. It worked however the fans didn't stop spinning at max rpm. I tried removing the card and it was still the same. Tried reseating the graphics cards, no luck. Of course everytime I would install the card or replace it, I had the system off.
Decided to update the BIOS
Old: 3.16
New: 3.94
No luck, now I'm getting a message when starting the computer "thermal sensor not programmed". Tried the recommended fix of unplugging the AC power and cycling the power. When that didn't work I decided maybe updating the ME firmware might help.
Old: 8.1.31.1351
New: 8.1.72.3002
The system fully boots it's just the fans never idle and the bios message prevents smooth reboots. Any ideas are welcomed.
System config:
Z820
E5-2670 x 2
128 ECC Ram